Inc Ventilation Hood Installtion Instructions

12
WOLF PRO VENTILATION HOOD LINERS
IN-LINE AND REMOTE BLOWERS
BLOWER INSTALLATION
I
MPORTANT NOTE:
R
efer to the specific
installation instructions provided with each
blower for additional mounting instructions.
Locate the blower so that the length of the
duct run and number of elbows and transitions
are kept to a minimum. Wolf recommends the
maximum linear duct run be no greater than
50' (15 m).
If possible, remote blowers should be located
between wall studs or roof rafters. Avoid
pipes, wires or other ductwork that may be
running through the wall.
Be sure that there is enough space for any
transitions that may be needed between the
blower and the connecting ductwork. For best
performance, locate transitions nearest the
blower.
Remove the two knock-outs in the top plate of
the liner when using a remote blower. Refer to
the illustration below.
Refer to the illustrations below and on the
following page for overall dimensions of Wolf
i
n-line and remote blowers. Also refer to the
specific installation instructions provided with
each remote blower to verify cut-out dimen-
s
ions.
18"
(457)
22"
(559)
24
7
/8
"
(632)
12"
(305)
18"
(457)
8"
(203)
Dimensions for BLOWER-110IL
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
Liner top plate knock-outs
Knock-outs