Operation Manual

10
Storage
For storing the rechargeable shears select a
dry place out of the reach of children and insure
that this area is free of frost in the winter.
Cleaning
• Clean the cutter head with a dry cloth after
each trimming.
• The drive should be cleaned and lubricated
at the end of the gardening season (see
„change cutting blades“).
Attention!
• Under no circumstances should you
activate the switch while cleaning the
device (figure B2, position 2).
• Drive repairs may only be carried out by a
WOLF service facility!
Change Cutter *
1. Remove skid (figure W1)
Unscrew screws.
2. Replace cutting head (figure W2/W3)
Remove the cutting head from the
rechargeable shears. Lubricate the ring
of the cutter with the lubrication tube**
Maintenance
(W2) provided, clean the visible area of
the drive, and lubricate this as well with
the lubricant provided. Position the ring in
such a way that it is precisely placed over
the eccentric tappet (W3).
3. Fastening the skid (figure W4)
Fix the screws.
Replace batteries
1. Remove cover (figure W5)
Place a coin in the cover slot and press
in the direction of the blade (1). Remove
the cover from above (2).
2. Replace batteries (figure W6)
Remove both plugs from the batteries
remove the batteries from the shears.
Place the new batteries in the shears
and connect the two plugs.
3. Fastening the cover (figure W7)
Push the lid with the projection (1) under
the edge of the shears and then press
the cover on the shears (2).
Note: Please ensure that no cable
protrudes from the shears when
fastening the cover!
* For replacement blades see accessories
** Part of the „replacement blade package“
Please carefully retain the guarantee card
completed by the seller, or the proof of
purchase.
The company WOLF-Garten provides a guarantee
for 24 months from the date of purchase. This
guarantee is in accordance with the relevant
state of technology and the utilisation purpose
/ area of application. The consumer‘s statutory
rights are not affected by the following guarantee
guidelines.
Pre-conditions for the 24-month guarantee
entitlement:
- Deployment of the device solely for private
use.
The guarantee is reduced to 12 months in the
commercial sector or leasing business.
- Proper handling and observance of all in-
formation given in the operating manual, which
forms part of our guarantee terms.
- Observance of the prescribed maintenance
inter-vals.
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts
/ accessories.
- Presentation of the completed guarantee card
and/or proof of purchase.
This guarantee does not extend to normal wear-
and-tear on blades, blade mounting components
or friction disks, V-belts/toothed belts, running
wheels/tyres, air filters, spark plugs and spark
plug connectors. Any guarantee claim shall be
immediately void in the event of unauthorised
repairs. Faults and defects which can be traced
to material or manufacturing faults will be rectified
exclusively by our contracted workshops (the
seller has the right to remedy a defect) in your
vicinity, or by the manufacturer if the latter is
closer. Any claims going beyond the provision of
a guarantee are ruled out. There is no entitlement
to a replacement. Any transport damage should
be reported not to us but to the shipper in question
since, otherwise, any compensation claims vis-à-
vis the shipper would be voided.
Guarantee terms