Operation Manual

16
G
Storage
1 Caution! Sharp cutting edges!
Before storing away the secateurs:
z Remove the battery .
z Store the secateurs in a dry location and out-
side the reach of children.
Replacing the blade
z Blunt blades should not be resharpened but
replaced.
z The fixed counter blade is not a wear part and
must normally not be replaced.
1 Always have the blade replaced by a
specialist workshop.
Adjusting the blade
1. Remove the battery .
2. Loosen or secure the blade:
– If the blade is fixed too tightly, turn the Al-
len key carefully anticlockwise by one
notch
(1).
– If the blade is too loose, turn the Allen key
carefully clockwise by one notch (2).
3 Instructions re. notches:
z When turning the key, the notches can
be easily felt.
z They correspond to an angle of 12°.
3. Place the battery in the secateurs and switch
on the tool.
3 If the blades adjustment is still not cor-
rect, repeat the above steps 1 to 3.
Troubleshooting
D
G
D
G
G
Problem Possible causes Remedy
Poor cutting performance
Blade is blunt
Bring the secateurs to the WOLF Ser-
vice workshop
Blade is loose Tighten the screw
(2)
Secateurs switch off inad-
vertently
Load too great (branch diameter
too large)
Cut only branches with diameters of
maximum 20 mm
Blade protection and blade blo-
cked
Remove battery, remove object that
blocks the tool
Blade screw too tightly secured Loosen screw (1)
Battery overheating (tempera-
ture exceeding 60°C)
Allow battery to cool down
Battery flat Recharge battery
Secateurs cannot be
switched on
Battery flat Recharge battery
Battery defective Replace battery
Charger: No charging
(red LED constantly on)
Battery temperature below 0 °C
or above 60 °C
Allow battery to cool down or heat up
Battery defective Replace battery
Charger: Malfunction (red
LED flashes)
Contacts dirty Clean contacts
Battery defective Replace battery
G
G