Operation Manual

14
15
Storage
For storing the rechargeable shears select
a dry place out of the reach of children
and insure that this area is free of frost in
the winter.
Cleaning
• Clean the cutter head with a dry cloth
after each trimming.
• The drive should be cleaned and
lubricated at the end of the gardening
season (see „change cutting blades“).
Attention!
• Under no circumstances should you
activate the switch while cleaning the
device
C
(2).
• Drive repairs may only be carried out by
a WOLF service facility!
Change Cutter *
1. Remove wheels
D
Carefully pull the wheels apart until they
come off the rechargeable shears. Then
remove the wheels from below.
2. Remove skid
E
Lever the retainer (1) upwards and then
remove the skid from the rear (2).
Maintenance
3. Replace cutting head
F
G
H
J
Remove the cutting head from the
rechargeable shears. Lubricate the
plastic ring of the cutter with the
lubrication tube**
F
provided, clean the
visible area of the drive, and lubricate
this as well with the lubricant provided.
Turn the new cutter head with the
plastic ring in the direction of the drive.
Note for shear blades (Accu 8 EM,
Accu 10 EM):
Please ensure that the blades are
staggered in relationship to each other
H
(1).
Note for shrub blades (Accu BS EM):
Position the plastic ring in such a way
that it is precisely placed over the
eccentric tappet
G
.
Push the blade diagonally under the
projections
H
(2) and position it in the
recharageble shears so that the drill
holes of the blade
J
sit above the
bolts of the rechargeable shears.
4. Fastening the skid
E
Push the skid far enough over the
rechargeable shears until the skid
retainer snaps in place.
5. Positioning wheels
K
* For replacement blades see accessories
** Part of the „replacement blade package“
Operation
Powering the shears on / off
C
1. Push the switch (1) forward and hold it
2. Press button (2)
3. Release switch (1)
4. Power off shears: Release button (2)
Attention! Please follow the safety
instructions!