Operating instructions

12
G
Fit the collecting basket
1 Caution! Rotating cutters
Settings only to be carried out on the mower with the motor
switched off and with the cutting tools at a standstill.
z Only insert the collection basket when your feet are at a
safe distance from the cutting tools.
1. Lift the protection cover.
2. Hang the collection basket in the notches in the chassis (see
arrow) using the hooks.
3. Apply the protection cover.
Feed cable through the strain relief
z Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3 Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an
electrician.
Starting and Stoping
z Switch on motor with mowerplaced on level and firm ground.
z not in high grass - alternatively tilt slightly .
Switch-on motor
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release bar (1).
Switch-off motor
z Release bar (2).
Emptying of Grassbox
The grassbox is full and should be emptied as soon as grass clip-
pings remain uncollected on the ground behind your mower.
1 Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Empty collection bag.
z Remove potential blockages in the cutting space before
starting.
Tips for mowing
z To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters .
z Always let cable trail on the cut side of the lawn.
Maintenance
General
1 Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
Cleaning
z Clean mower thoroughly after each mowing with cloth or
brush.
z Do not spray with water.
Winter Storage
z Clean mower thoroughly before storing away.
z Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
z Do not store it in a wet or humid place.
Cutter bar
z Before undertaking any work on coupling and cutter bar, first
pull out the plug and wear safety gloves.
1 Caution!
Let a specialist workshop attend to work on knife.
z At the conclusion of any work on coupling and cutter bar,
carry out insulation test according to the prevailing valid
standard.
z Regrinding the knife may result in mass imbalance.
Therefore, unbalance test according to the correspon-
ding safety requirement is essential.
z To replace the cutter bar, a torque wrench of size 13 mm
is very essential. Bolt tightening torque: 15 Nm.
z Use only the original WOLF-Garten spares.
Spare parts
H
J
K
L
M
M
N
O
Item number Order description Product information
WG742-04355 Vi 32 D Replacement blade 32 cm
WG742-04359 Vi 38 D Replacement blade 38 cm