Operation Manual
9
Maintenance (fig. W1)
Important! Disconnect from power supply before performing maintenance and cleaning. Clean the machine without water
after each use. Please note: the air intake slots of the electric motor must be freed from grass and moss accumulations! Do not
spray machine with water. Store machine in a dry room.
We recommend
Allow a WOLF-service centre to check the unit in the autumn.
Maintenance
Insert connection cable in the strain relief (fig. B2)
Insert coupling of connection cable (3) in the socket of the switch (J). Then guide the cable (4) from outside in a slight loop over the
peg (5) of the strain relief assembly (I).
Connection to the power outlet
(230 Volt AC, 50 Hz). The machine can be connected to any power outlet that is protected by a 10 amp fuse (or line protecting
switch type K - formerly H).
Note:
Use a residual current protection device with a residual current of no more than 30 mA.
Motor on (fig. B2)
Press button (1) and hold.
Lift lever (2) and release button (1).
Motor off (fig. B2)
Release lever (2).
Attaching catch bag* (fig. B3)
Lift protective flap (O). Hang catch bag (1) with the hooks on both bolts** of the side elements.
(* TK 33 3615 060, accessory at additional cost, ** bolts included with catch bag)
Operation
Please carefully retain the guarantee card completed by the seller, or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months from the date of purchase. This guarantee is in accordance with the relevant state
of technology and the utilisation purpose / area of application.
The consumer’s statutory rights are not affected by the following guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector or leasing business.
- Proper handling and observance of all information given in the operating manual, which forms part of our
guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of purchase.
This guarantee does not extend to normal wear-and-tear on blades, blade mounting components or friction disks, V-belts/toothed belts, running
wheels/tyres, air filters, spark plugs and spark plug connectors.
Any guarantee claim shall be immediately void in the event of unauthorised repairs.
Faults and defects which can be traced to material or manufacturing faults will be rectified exclusively by our contracted workshops (the seller has
the right to remedy a defect) in your vicinity, or by the manufacturer if the latter is closer. Any claims going beyond the provision of a guarantee are
ruled out. There is no entitlement to a replacement.
Any transport damage should be reported not to us but to the shipper in question since, otherwise, any compensation claims vis-à-vis the shipper
would be voided.
Guarantee terms
Faults and how to remedy
Remedy (X) by:
Problem Possible Cause
WOLF
Service-
Worshop
Your-
self
No scarification result • The working depth is set too low --- X
Machine runs unevenly, with heavy
vibrations
• Blade is damaged due to contact with hard objects X ---
Motor switches off (overheating
protection)
• Machine is overloaded (adjust blade height)
• The air intake slots of the electric motor must be freed from grass
and moss accumulations!
---
---
X
X
Motor will not run
• Fuse blown
• Cable damaged
Important! If you inadvertently cut through the cable, the fuse (10 Amp.) will not
always blow. In the interest of safety, never touch damaged or servered cables
before disconnecting the mains plug. Repairing the cable with insulating tape is
prohibited.
---
X
X
---
When in doubt, always consult a WOLF service workshop.
Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.