Installation Guide

Preparation
Before moving the oven, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
Use an appliance dolly to move the oven near the
opening. Place the appliance dolly on the side or back to
prevent damage. Remove and recycle packing materials.
Do not lift or carry the oven by the door handle.
Oven Door Removal
To lighten the load, the oven door(s) can be removed.
Remove only if necessary. Door removal should be done
only by a certified installer or service technician. Do not
lift or carry the oven door by the door handle.
To remove, open the door completely. Rotate both hinge
locks back completely, remove the screw closest to the
hinge on both sides of the door, and pull the door
forward.
To install, slide the door onto the hinges. Rotate the hinge
locks forward completely and install the screws.
HINGE
LOCK
SCREW
Electrical Connection
WARNING
Verify that power is disconnected from the electrical
box before proceeding.
If the electrical supply is located in the opening, electrical
connection must be made prior to placing the oven in the
opening. If the electrical supply is in an adjacent cabinet,
electrical connection can be made after placing the oven
in the opening. The conduit on the back of the unit allows
for a 3-wire or 4-wire installation.
1
Connect the black appliance wire to the black (L1)
power supply.
2
Connect the red appliance wire to the red (L2) power
supply.
3
Connect the bare appliance wire to the green/ground
wire.
4
For a four-wire system, install a wire nut on the white/
neurtral wire.
Installation
Place the oven in the opening and slide into position. To
ensure adequate depth for proper installation, the conduit
must fit into the recessed area along the rear edge of the
oven.
Locate the mounting hole in each side trim. Drill 1/16" (2)
pilot holes and install #6 x 3/4" screws.
Remove and recycle packing materials including the
white protective material behind each rack guide
mounting location.
Installation
Preparation
12
|
English