Owner's manual

ManualsBrandsWolo ManualsEquipment4200 The Commissioner

THE COMMISIONER

200 WATT ELECTRONIC SIREN

& PA SYSTEM Model 4200

Your purchase of a Wolo electronic siren, THE COMMISIONER, is the perfect choice for reliable service. THE

COMMISIONER is manufactured with the finest materials and each siren is tested to meet our high standards,

ensuring a perfect working siren controller. Wolo’s quality workmanship and components are your assurance that

this product will provide years of dependable service. If you need help with installation or in using your new Wolo

siren, our technicians are available to answer your questions, Monday thru Friday, from 9 AM to 4 PM EST at 1-888-

550-4676.

Before installation of the siren is attempted, it is important to read these instructions completely. The lives of people

are dependent on the proper installation of this product. The person installing this siren must have advanced

knowledge of the proper method for installation of emergency warning equipment, connecting and securing wires to

a vehicle’s electrical system and knowledge of the vehicle's electrical system. Again, read this manual completely

and note any messages marked “IMPORTANT” or “WARNING’’. A safe installation will prevent serious injury or

damage to the vehicle.

Sound Hazard

IMPORTANT: This siren, like all effective sirens, produce a powerful audible sound that could cause permanent

hearing loss. Note: Hearing loss can occur from short exposure to very loud sounds and or long exposure to

moderate loud sounds. To protect your hearing and the hearing of others in or close proximity to the emergency

vehicle using this siren, always use proper ear protection. Refer to federal, state, local municipality regulations and

OSHA Standard 1910.95 for guidelines of “Permissible Noise Exposure’’

Summary of content (5 pages)

PAGE 1
THE COMMISIONERTM 200 WATT ELECTRONIC SIREN & PA SYSTEM Model 4200 Your purchase of a Wolo electronic siren, THE COMMISIONER, is the perfect choice for reliable service. THE COMMISIONER is manufactured with the finest materials and each siren is tested to meet our high standards, ensuring a perfect working siren controller. Wolo’s quality workmanship and components are your assurance that this product will provide years of dependable service.
PAGE 2
INSTALLATION RECOMMENDATIONS • For maximum sound be sure that the speaker connected to THE COMMISIONER siren controller is not less then 200 watts. Recommended Wolo speakers is: Model 4004, or two 100-watt speakers Model 4002 or 4003. • The speaker or speakers should be mounted facing forward on the vehicle. To obtain maximum sound output, make sure that the speakers are unobstructed. The siren’s sound can be severely reduced if objects are in front or blocking the speaker.
PAGE 3
HARNESS WIRE INFORMATION Fig. 2 8. The wire harness provided with the siren has a male plug end that mates with the connector located in the back of the siren controller. The plug is designed to connect and lock only in one position.
PAGE 4
ACCESSORY ROCKER SWITCHES: ACCESSORY ROCKER SWITCHES: LEFT ROCKER SWITCH IS CONTROLLED BY PINK WIRES LEFT ROCKER ISconnected CONTROLLED PINK WIRES 14. PINK FUSEDSWITCH WIRE: is to theBY vehicle’s fuse-block or a under dash power source that can supply 1214. volts PINK/ FUSED WIRE: is connected to the with vehicle’s fuse-block or a under source that 1215-amps. The pink wire is provided an in-line fuse that must be dash used. power The fuse should notcan be supply more then volts / 15-amps.
PAGE 5
SPECIFICATIONS: Siren controller • 12-volt / 200 watts maximum output • L 6 in. x Depth 7-1/2 in. x H 2-1/2 in. • Current 6.5 amperes volume control set at maximum • Case is all metal black enamel painted • Adjustable metal stainless steel swing bracket provided • Illuminated front control panel by LED’s • Noise canceling microphone • Power harness is six-(6) ft. in length and has an inline fuse-holder • Weight 4 pounds (controller without swing bracket) Cycle Rate ......................................