Instructions / Assembly

ManualsBrandsWOODBRIDGE ManualsBathEverette 1-Piece 1.28GPF Dual Flush Elongated Toilet in White with Map Flush 1000 g and Toilet Seat Included

WOODBRIDGE

REMOVE OLD TOILET

1. Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line.

2. Flush the old toilet and make sure that tank is empty.

3. Disconnect and remove water supply line connected to the toilet's tank.

4. Remove old toilet, bolts, nuts from the closet flange.

5. Clean closet flange area from old wax ring and putty sealant using putty knife from the base area.

6. Clean any remaining debris and wipe any water at the installation area

7. Temporarily plug flange on a floor with a flange plug or towel to prevent gasses from escaping

PREPARE CLOSET FLANGE

Figure 5

INSTALL WAX RING

Important: safety glasses must be worn by the installer

and all bystanders.

Cover the floor with a soft-close blanket. Carefully turn

the toilet on it's side or upside-down on the blanket with

assistance of a second person. Install wax ring over the

horn discharge located on the bottom of the toilet's bowl.

See Figure 5

Note: Ceramic is a fragile material. You must always cover

the floor with a soft-cloth blanket if you want to put the

toilet on the floor on any side other than the bottom of

the toilet. If you do not cover the floor with a soft-close

blanket contact of the toilet with the floor may and will

cause minor or moderate scratches on the toilet's surface.

Prior to installtion the

wax ring must be kept in

a room temperature

between 70-75ºF.

IMPORTANT! The mounting surface area

must be clean, dry, and leveled prior to

installation of the new toilet!

NOTE! Inspect the existing closet flange for

damages. If damaged, replace it to new flange

before proceeding to the installation

Always Use Soft-Cloth Blanket

www.woodbridgebath.com

Figure 1

Figure 2

Step 1

Step 2

Bathroom

Wall

Bathroom

Floor

Closet Flange

12"

Rough-in

90º

Bathroom

Wall

Bathroom

Floor

Bathroom

Wall

toilet template

Figure 3

Pencil

Locate and remove template from carton. Place over toilet flange. Measure from back wall to make sure it is square/even with wall.

Check your shut-off valve to make sure it clears back of template. See Figure 3

IMPORTANT! Shut off main water supply prior to installation!

Figure 4

Using template outline the area

where the toilet will sit with pencil

or tape to more easily locate flange

bolts and make a solid connection

between wax ring and flange when

set. Make sure to remove template,

leaving outline before installing.

See Figure 4

Step 1. Insert 2 floor

bolts inside of the toilet

flange Step 2. Slide the

closet bolts through

the holes and align bolts

horizontaly. See Figure 2

Make sure that rough-in is 12" by measuring the distance from the wall to the center of the closet flange. See Figure 1

Bathroom

Floor