Instructions / Assembly

ManualsBrandsWOODBRIDGE ManualsBathEverette 1-Piece 1.28GPF Dual Flush Elongated Toilet in White with Map Flush 1000 g and Toilet Seat Included

WOODBRIDGE

CONNECT TOILET'S TANK

TO WATER SUPPLY LINE

Connect the water supply line between the tank and water

shut-off valve using a toilet hose (not supplied). When

connecting toilet hose tighten coupling nut to the tank by

1/4 turn beyond the hand tight.

Turn on valve on water supply line and allow tank to fill.

Check all connections for leakages and tighten as needed.

Once tank is filled with water flush it 4-5 times to perform

a test of the flushing system. At the same time check the

bottom of the toilet for leaks to make sure that the wax

ring is properly installed and sealed.

If there are no leaks you are ready finalize the installion. If

any shims are installed at the bottom of the toilet's bowl

you may trim them. Apply silicone around base of the

toilet's. Allow 24 hours for silicone to dry before start

using the toilet. See Figure 8

Important: Leaks may not occur during or right after the

installation. Make sure to check for leaks every couple

hours first day installed and and occasionally check it

everyday for the next week to ensure that toilet is properly

installed and no leaks occur. If any leaks occur immediately

shut off the water supply line valve and contact your local

plumber to fix all leaks.

Important:

Under no circumstances will we be liable for any and all incidental damages

sustained in connection with this product

Neither manufacture, nor distributor, nor retailer is responsible for water

damage or flood caused due to use of this product.

Under no circumstances will we be liable for any and all fees, cost of

installation/reinstallation/removal, subsequent damage or transportation in case

of the product defect

Figure 6

Figure 7

Figure 8

INSTALLATION INSTRUCTIONS

INSTALL NEW TOILET

Wall

Floor

Note: It may be required to use shims

under the edge of the toilet's bowl. Due to

manufacturing process of vitreous china

ceramic products, every toilet may have

slight level variations. It does not mean

that the toilet is defective. In addition

12"

Rough-in

Standard

Wall

Floor

Do not overtighten nut on the tank connection.

It may and will cause water leakage.

WOODBRIDGE

DELUXE ONE PIECT TOILET

www.woodbridgebath.com

Bathroom

Floor

Bathroom

Floor

Step 1. Lift and carefully put the toilet over the closet

flange inside the outline made by template so the closet

bolts can go through the mounting

holes in the toilet's base. Once the bowl is in the position

press the bowl down with slight twisting motion in level

position towards the floor. Apply your body weight to

evenly compress the wax ring to create watertight seal.

Make sure that the bowl is as leveled as possible to have a

nice seal tight.

Do not rock the toilet back and forth and side to side as it

may and will break a seal and you will need to replace the

wax ring again and start the installation process over.

See Figure 6

Step 2. Once the toilet is set and leveled install washers

and nuts over the closet bolts. Tighten nuts. Do not

overtighten the nuts. It may and will cause damage to the

toilet's ceramic base. Please keep in mind that because this

is a skirted trap-way toilet, it may require a little more time,

patience and accessibility to complete install. See Figure 7

Using Hand Wrench

Included in Box