Instructions / Assembly

ManualsBrandsWOODBRIDGE ManualsBathEverette 1-Piece 1.28GPF Dual Flush Elongated Toilet in White with Map Flush 1000 g and Toilet Seat Included

WOODBRIDGE

ADJUSTMENT & MAINTENACE (FILL VALVE)

Instructions:

When valve installed, the critical level mark

on fill valve (identified by C.L. mark on

valve body) shoud be at least 1" above top

of the over flow pipe.

Required:

• Water temperature: 36-112ºF

Important:

Under no circumstances seller shall not be liable for any and

all incidental damages sustained in connection with this

product

Neither manufacture, nor distributor, nor retailer is

responsible for water damage or flood caused due to use of

this product.

Under no circumstances seller shall not be liable for any and

all fees, cost of installation/reinstallation/removal,

subsequent damage or transportation in case of the product

defect

95mm

58mm

Max 289mm, Min 189mm

ax 344mm, Min 244 mm)

Max 230mm, Min 90mm

(Max 285mm, Min 145 mm)

Max 19

.5mm - Min 8.5mm

45mm

Check the fill valve and

make sure that it does

not have any damaged or

missing parts

1. Press buckle and unscrew.

2. Pull the valve upwards or press down to desired height.

3. Unscrew the valve body and fasten the buckle

Rotating screw, rise or lower the water level

to adjust water level to suitable position

(water volume will gradually increase when

the adjuster is moved upward from the

bottom.)

1. PREPARATION

2. WATER LEVEL ADJUSTMENT

ress and

unscrew

Solution 1

ull upwards

ress down to

esired height

nscrew

ockwise

nd fasten

alves

otate screw to adjust

esired water level

Solution 2

Install the valve into tank. Do

not use any wrench tools.

Fasten with hand only.

Connect water supply to the fill

valve. Turn on water.

Turn off water supply valve

before height adjustment of the

toilet's fill valve.

Put the refill tube into the white

cap hole firmly.

3. FILL VALVE INSTALLATION

IMPORTANT: Do not use or drop any chlorine or any other chemicals. Use of chemical products will result in damage to the fill

valve and flush valve components and may cause flood and property damage. Do not overtighten bolts/nuts as it may and will

cause damage to the toilet parts and componets.

Important Note: Flush GPF amount is factory set. No addional adjustment is required. This page is for reference only.

All adjustments are already made by manufacturer.

.L.

WOODBRIDGE

DELUXE ONE PIECT TOILET

Remove the worn-out fittings and clean your tank prior to the installation of the new ones. There might be a lot of impurities in your

tank that may cause damage to the new parts if you do not clean them out. The tank must be absolutely clean prior to installation.