G G ID R B INSTALLATION AND CARE GUIDE D O O W WOODBRIDGE R 7RLOHW %LGHW 6HDW R R E G R E G W E G D I R B D O O W R W E G &RPSOLDQFH ZLWK WKH IROORZLQJ 3OXPELQJ &RGHV 6WDQGDUGV ® á 8QLIRUP 3OXPELQJ &RGH D I R 83& ® á ,QWHUQDWLRQDO 3OXPELQJ &RGH B D ® á :DWHU6HQVH &HUWLILHG 7RLOHW O O W ,3& á &6$ % ,$302 = 3ODVWLF 3OXPELQJ )L[WXUHV ICC SCC Accredited CB-P/S TM LISTED OCPS Accrédité CCN ANSI ACCREDITED ISO/IEC 1706
WOODBRIDGE R READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT ,16758&7,216 7+$7 ,) ,*125(' &28/' 5(68/7 ,1 '($7+ 25 6(5,286 ,1-85< &$86(' %< ,1&255(&7 +$1'/,1* 25 ,167$//$7,21 2) 7+( 352'8&7 7+(6( ,16758&7,216 0867 %( 2%6(59(' )25 6$)( ,167$//$7,21 3(23/( $5( 5(48,5(' 72 /,)7 $1' '85,1* (17,5( ,167$//$7,21 2) 7+,6 352'8&7 ,167$//$7,21 2) THIS 352'8&76 %< $1 ,1(;3(5,(1&(' ,167$//(5 0$< 5(68/7 3(5621$/ ,1-85< 25 '($7+ We 8'9'8='9 ;,' 8-+,; ;3 $,!2+'T <6&!;'T 13&-(@T !£;'8T 8'&'9-+2 ;,-9 1!2
WOODBRIDGE R DIMENSIONS/TECHNICAL DATA cz cz ¤ c¥z c¥z cz c¥z c¥z cz c¥z c¥z c¥z 3<+,f-2 z S;!2&!rd IMPORTANT j '!9<8'1'2;9 !8' c¥z !2& 9<#/'$; ;3 $,!2+' >-;,3<; 23ধ$' INFORMATION j £'!9' 23;' ;,!; -29;!££'8l9m 1<9; #' $'8ধ)'& 38 >!88!2;@ >-££ #' =3-&'&W j 6'$-)$!ধ329 { 32)+<8!ধ329 !8' 9<#/'$; ;3 $,!2+' >-;,3<; 23ধ$' j '!9<8'1'2;9 ,'8'-2 9<6'89'&' !££ 3;,'89 6<#£-9,'& 68-38 ;3 j £'!9' 1'!9<8' ;3-£'; 32f9-;' #'(38' -29;!££!ধ3
WOODBRIDGE R WATER SUPPLY LOCATION & TECHNICAL INFORMATION Side View Back View !££ Threaded ,<20 l !;'8 <66£@ -££ !£='m 3<+,f-2 z ;!2&!8& £338 Side View !££ Tank Top View (Inside) <££ £<9, lW¤ m 3<+,f-2 £338 z ;!2&!8& !£( £<9, l m IMPORTANT j '!9<8'1'2;9 !8' c¥z !2& 9<#/'$; ;3 $,!2+' >-;,3<; 23ধ$' !£( £<9, l m £<9, !13<2; -9 (!$;38@ 9';W 3 !&&-ধ32!£ !&/<9;1'2; -9 8'7<-8'&W &/<9; ;,' >!;'8 £'='£ -2 ;,' ;3-£';y9 ;!20 -( 2'$$'99!8@ #@
WOODBRIDGE R ,03257$17 6KXW RII PDLQ ZDWHU VXSSO\ SULRU WR LQVWDOODWLRQ 1. Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line. 2. Flush the old toilet and make sure that tank is empty. 3. Disconnect and remove water supply line connected to the toilet's tank. 4. Remove old toilet, bolts, nuts from the closet flange. 5. Clean closet flange area from old wax ring and putty sealant using putty knife from the base area. 6.
WOODBRIDGE R CAUTION! 3(23/( $5( 5(48,5(' 72 /,)7 $1' '85,1* (17,5( ,167$//$7,21 2) 7+,6 352'8&7 !££ ;'6 W Lift and carefully put the toilet over the closet flange so the closet bolts can go through the mounting holes in the toilet's base. Once the bowl is in the position press the bowl down with slight twisting motion in level position towards the floor. Apply your body weight to evenly compress the wax ring to create watertight seal.
WOODBRIDGE R ADJUSTMENT & MAINTENANCE (DUAL FLUSH VALVE) 1638;!2; 3;'V £<9, !13<2; -9 (!$;38@ 9';W 3 !&&-ধ32!£ !&/<9;1'2; -9 8'7<-8'&W ,-9 6!+' -9 (38 8'('8'2$' 32£@W ££ !&/<9;1'2;9 !8' !£8'!&@ 1!&' #@ 1!2<(!$;<8'8W W Gasket Check the dual flush valve and make sure that it does not have any damaged or missing parts Install the base with the rubber gasket in the tank, turn the screw as illustrated to make sure there is no water leakage and no looseness Install a body of th
WOODBRIDGE R ADJUSTMENT & MAINTENACE (FILL VALVE) 1638;!2; 3;'V £<9, !13<2; -9 (!$;38@ 9';W 3 !&&-ধ32!£ !&/<9;1'2; -9 8'7<-8'&W ,-9 6!+' -9 (38 8'('8'2$' 32£@W ££ !&/<9;1'2;9 !8' !£8'!&@ 1!&' #@ 1!2<(!$;<8'8W Instructions: When valve installed, the critical level mark on fill valve (identified by C.L. mark on valve body) shoud be at least 1" above top of the over flow pipe.
WOODBRIDGE R CLEANING & TROUBLESHOOTING (FILL VALVE) Shut off water supply line before filter cleaning. Carefully, take out the filter from inlet by using pliers. Use water to wash and clean the filter and adapter from any debris. Re-install the filter and re-connect the water supply line.
%LGHW 6HDW ,QVWDOODWLRQ ,QVWUXFWLRQV When using electrical products, especially when children are present, basic safety precautions shouldalways be followed, including the following: 1.The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. 2.Children being supervised not to play with the appliance. 3.
WOODBRIDGE R CAUTION – Indicates that failure to follow the instruction may cause body injury or property damage. 1. Do not install or use the product in wet places as steam room etc.This product must be connected to properly grounded power outlet socket. 2. It is recommended to use water-proof electrical outlet which should be lnstalled in the place where is not easily got wet. 3.
WOODBRIDGE Main Unit R Rating pressure AC 110-120V,50/60Hz Rating power 1050-1250W Water pressure range Minimum water pressure 0.07MPa (20L/min. flowing pressure). Maximum water pressure 0.8MPa (Hydrostatic pressure) Electrical wire length is about 1.
WOODBRIDGE R Components Name Release button Lid Buffer Leakage protection plug Infrared receiver Power cord Water supply pipe Nozzle baffle Drying baffle Seat Nozzle Rear cleaning Front cleaning Whole set of product www.woodbridgebath.
WOODBRIDGE R Main Unit Knob Instructions (Knob Applies) Back Front Rear Cleaning Knob 1. When people is seated, turn Rear Cleaning Knob forward to start rear FOHDQLQJ IXQFWLRQ 5HDU FOHDQLQJ DERXW PLQV ĺ 'U\LQJ DERXW PLQV ĺ6WRS GU\LQJ DXWRPDWLFDOO\ 2. During rear cleaning, turn the knob forward, the washing position moves forward, otherwise, the washing position moves backward. Front Cleaning Knob 1.
WOODBRIDGE R Technical Specification Main Unit Cleaning device Rated voltage 110-120V，50/60Hz Rated power 960W Water pressure range The minimum necessary pressure 0.08MPa (hydrostatic pressure), the maximum water pressure 0.8MPa (hydrostatic pressure) Power Cord length is about 1.
WOODBRIDGE R Packing List 1.Remote control The remote control assembly Remote control rack Remote control Batteries (3) 2.Remote control rack Expansion screws (2) 3.Expansion screws (2) 4.Batteries (3) Screws 1.Base plate Base plate assembly Fixed piece 2.Screws (2) Floor 3.Fixed piece (2) Expansion nut 4.
WOODBRIDGE R Product Size and Installation Preparation Tool 130-190mm 403mm 380mm Phillips screwdriver 517mm 434-493mm ＞490mm ＜90 ＞25 ＋ Tape measure * Tips: Please confirm this seat fitting your current toilet. Wrench Cup Installation of Main Unit * This product has been tested for water flow before leaving the factory. There may be a small amount of residual water dripping out when removing the product, which is not a malfunction.
WOODBRIDGE 3 R Installation of Water inlet pipe and Tee joint Connect to Water supply pipe Current toilet water supply pipe Connect to main unit Connect to the angle valve Water Inlet pipe Tee Joint Angle Valve ① Connect Tee joint to angle valve; (The original Tee joint should be removed); ② Connect the inlet end of water supply pipe to Tee joint according to the above illustration; ③ Connect main unit to Tee joint according to the above illustration. 17 www.woodbridgebath.
WOODBRIDGE R Preparation for Start-Up 1. Turn on the angle valve Check the tightness of the threaded connection to ensure that there is no water leakage. Turn the angle valve counterclockwise to adjust the opening to the maximum. (Tips: when the valve is opened for the first time, the angle valve handle has a large torque) Angle valve 2.
Daily Maintenance Maintenance of Main Unit 1.Turn off the power during maintenance of this machine. 2. Wipe the dirty area with a soft cloth that is wrung out of water. 3. After wiping, please turn on the power again. Neutral cleaner Tips: Do not rinse the surface of the product directly with water during maintenance. Maintenance of the Nozzle When there is dirt on the nozzle, maintain it according to the following methods: 1.
WOODBRIDGE R Self-cleaning Waterway Maintenance Current-limiting shaft Current-limiting nut Self-cleaning waterway maintenance： When the self-cleaning waterway is blocked, there is no water coming out during self-cleaning process. Note: Cut off power prior to discharging the water. 1. Turn off the angle valve. 2. Unplug the power plug, cut off the power. 3.
WOODBRIDGE R Troubleshooting Guide Problem Cause Solution Water inlet hose bent to cause blocking Solve the problem of bending of water inlet hose Inlet valve is off Turn on the inlet valve Water supply is cut off Water inlet hose bent to cause partial blocking Connect water supply and wait for the water Solve the problem of bending of water inlet hose Water inlet valve is not fully open Turn on the inlet valve fully Inlet filter blocked Clean the filter The water temperature is set in normal
E G G ID Troubleshooting Guide D I R B Problem R B Cause Solution D O Solve the problem of bending of water inlet hose Water inlet hose bent to cause blocking No Water from Nozzle Inlet valve is off O W Turn on the inlet valve Connect water supply and wait for the water Solve the problem of bending of water inlet hose Water supply is cut off Water inlet hose bent to cause partial blocking Weak water cleaning Water inlet valve is not fully open Turn on the inlet valve fully R The water t
