Owner Manual
R
BRIDGE
WOODBRIDG
R
BRIDGE
WOODBRIDG
BRIDGE
WOODBRIDG
www.woodbridgebath.com
22
&XVWRPHU6HUYLFH3KRQH0RQGD\)ULGD\$0303DFLILF7LPH
2U(PDLOKHOS#ZRRGEULGJHEDWKFRP
,!20@3<(38<9-2+33&8-&+'683&<$;9R
Troubleshooting Guide
Problem Cause
No Water from
Nozzle
Water inlet hose bent to cause
blocking
Inlet valve is off
Water supply is cut off
Weak water
cleaning
Water inlet hose bent to cause
partial blocking
Water inlet valve is not fully open
Inlet filter blocked
Low water
temperature
The water temperature is set in
normal temperature level
low seat
temperature
The seat temperature is set in
normal temperature level
In standby mode
Solution
Solve the problem of bending of
water inlet hose
Turn on the inlet valve
Connect water supply and
wait for the water
Solve the problem of bending of
water inlet hose
Turn on the inlet valve fully
Clean the filter
Reset the water temperature
Reset the seat temperature
Switch to operating mode and use
it after 3 minutes
low wind
temperature
No wind out
Nozzle rod cannot
retract
Nozzle rod cannot
stretch out
Remote control
cannot display
Malfunction of
deodorization
Caution
The wind temperature is set in
normal temperature level
In standby mode or power saving
mode
Power off
Get stuck by impurities
Power off
No sitting in sensing area
The battery of the remote control
is installed in the opposite direction
User doesn't reach the
sensing area in seat
Deodorization function
keeps working after user
leaves
If the problems cannot be solved as per above methods, please turn
off the power , and contact service providers for maintenance.
If the power leakage protection switch always trips, it means that the
product is leaking. Please turn off the power, contact the service
provider, and ask for professional repairs.
It's a normal phenomenon if
deodorization function keeps
working after user leaves to
ensure eliminating smell entirely
Adjust to reach the sensing area
Reload the battery
Sit right in the sensing area
Put power on
Clear away the impurities
Push back the nozzle rod lightly
and put power on
Shift to operating mode to use
dry function
Reset the wind temperature