Owner Manual

ManualsBrandsWoodBridge ManualsBathroom Remodel & Bathroom Fixtures1.28 GPF (Water Efficient) Elongated Bidet Toilet

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

,03257$17

6KXWRIIPDLQZDWHUVXSSO\SULRUWRLQVWDOODWLRQ

$OZD\V8VH6RIW&ORWK%ODQNHW



1. Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line.

2. Flush the old toilet and make sure that tank is empty.

3. Disconnect and remove water supply line connected to the toilet's tank.

4. Remove old toilet, bolts, nuts from the closet flange.

5. Clean closet flange area from old wax ring and putty sealant using putty knife from the base area.

6. Clean any remaining debris and wipe any water at the installation area

7. Temporarily plug flange on a floor with a flange plug or towel to prevent gasses from escaping



Figure 1

Figure 2

Make sure that rough-in is 12" by measuring the

distance from the wall to the center of the closet

flange.

See Figure 1

Step 1. Insert 2 floor bolts inside of the toilet flange

Step 2. Slide the closet bolts through the holes and

align bolts horizontaly.

See Figure 2

Figure 3



1638;!2;Vsafety glasses must be worn by the installer

and all bystanders.

Cover the floor with a soft-close blanket. Carefully turn

the toilet on it's side or upside-down on the blanket with

assistance of a second person. Install wax ring over the

horn discharge located on the bottom of the toilet's bowl.

See Figure 3

Note: Ceramic is a fragile material. You must always cover

the floor with a soft-cloth blanket if you want to put the

toilet on the floor on any side other than the bottom of

the toilet. If you do not cover the floor with a soft-close

blanket contact of the toilet with the floor may and will

cause minor or moderate scratches on the toilet's surface.

Prior to installtion the

wax ring must be kept in

a room temperature

between 70-75ºF.

IMPORTANT! The mounting surface area

must be clean, dry, and leveled prior to

installation of the new toilet!

NOTE! Inspect the existing closet flange for

damages. If damaged, replace it to new flange

before proceeding to the installation

Step 1 Step 2

!;,8331

!££

!;,8331

£338

£39';£!2+'

z

3<+,f-2

C

Step 3

Step 4

Step 5 Step 6