Company Brush Cutter User Manual

Dealer Service 33
MAN0963 (2/16/2012)
Splitter Gearbox Inspection
1. Check gearbox for leaks by: plugging all holes
except one, applying 4 psi of compressed air, and
immersing gearbox in water. Verify gearbox does
not leak.
NOTE: Excessive air pressure will damage seals.
2. Remove gearbox from water and dry off.
3. Remove upper plug on right side of housing. Add
SAE 80W or 90W EP oil until it runs out side level
hole. Replace plug.
4. Install breather (24) in top cover.
Splitter Gearbox Installation
NOTE: Gearbox is heavy: do not attempt to move with-
out mechanical assistance.
Use loctite when mounting gearbox. Set gearbox on
cutter and fasten with bolts and nuts. Torque bolts to
170 lbs-ft.
Figure 15. Splitter Gearbox - Style A
2. 10 mm Lock washer
3. M10 x 1.5P x 30 HHCS
4. Input cap
5. Input shaft
6. Input oil seal
7. Bearing assembly (cup & cone)
8. Gasket .15 mm
9. Gasket .25 mm
10. Gasket .40 mm
11. Hub cap
12. Oil seal
13. Output shaft
14. Spacer
15. Shim .30 mm
16. Shim .40 mm
17. Shim .50 mm
18. Center gear
19. Wing gear
20. Bearing adjustment nut
21. 1/8 x 2-1/2 Cotter pin
22. Sealing washer
23. M18 x 1.5P Level plug
24. M18 x 1.5P Breather plug