Company Brush Cutter User Manual

Assembly 37
MAN0805 (4/30/2009)
Install CV Drive (BW180HD)- Optional
Before installing cutter input driveline to gearbox, check
the tag wired to the driveline and the tag wired to the
input shaft of gearbox. Ensure the tag rpm speeds
match the rpm speed decal on front of cutter. After con-
firming all speeds match, remove and discard tags and
then complete driveline assembly.
1. Align hole in drive yoke with groove on gearbox
input shaft and slide rear half of drive (23) onto
shaft.
2. Secure with bolt and nut supplied with drive.
Figure 29. CV Drive Installation
Install Wing (BW180HD)
 Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
The wing must be installed in the following sequence
and will require at least two people. A floor jack or a
suitable lifting device will be helpful to align decks when
installing the hinge pin.
Check RPM tags on wing and center section to make
sure they match before proceeding.
1. Remove hinge pin (15) from center section.
2. Place wing assembly adjacent to the center section
and align hinge sections.
3. Insert hinge pin through the hinge sections and
secure with spring pin (67) and washer (35) on
both ends.
4. Attach side skid (7) to the wing using four carriage
bolts (56) and flange lock nuts (55).
5. Repeat procedure of opposite wing.
Figure 30. Right Wing Installation
Install Wing Cylinder & Lock-up Bar
(BW180HD)
Figure 31. Wing Cylinder & Lock-Up Bar Installation
1. Place two cylinder links (23 & 24) on either side of
cylinder lug on center section as shown, align
holes and insert clevis pin (22).
23. CV Drive
CAUTION
7. Side skid
15.Hinge pin
35. 1" Flat washer
37. Spring pin, 1/4 x 1-1/2
55. 1/2 NC Lock nut
56. 1/2 NC x 1-1/2 carriage bolt
4. Hydraulic cylinder
17. Spacer, 1"
18. 1 x 2.72 Clevis pin
19. Wing lock-up bar
22. 1" x 4.08" Clevis pin
23. Cylinder link
24. Cylinder link
25. Spacer, 3/4
26. Lock-up pin 1" x 5"
27. Washer, 1 x 1-7/8
40. 1/2 NPT x 1/4 NPT
Reducer bushing
41. 1/4 NPT x 1/4 NPT
Restricted
42. 1/4 NPT x 1/4 NPT x
200" Hose
45. 3/16 Safety pin
66. 1/4 x 1-1/2 Cotter pin