Company TV Mount User Manual

8 Installation

PN-59756 (Rev. 4/9/01)

SUB-FRAME INSTALLATION Cont’d

Modify Loader Mounts

For tractors equipped with Woods 1006 Loader

Loader mounts manufactured prior to April 2001 will

need to be modified before reinforcement brackets

can be installed. Contact Woods Technical Service for

assistance.

NOTE: If rear mount has five slots on each side, pro-

ceed to next section, Install Right & Left Reinforce-

ment Brackets.

Install Right & Left Reinforcement

Brackets

For tractors equipped with either

New Holland 7106 or Woods 1006 Loader

1. After holes have been drilled, install right and left

reinforcement brackets (5, 6). Use cap screws (25),

washers (29), and nuts (28) in new drilled holes.

NOTE: Cap screws that attach the reinforcement to

the tractor clutch housing are different lengths on right

and left side of tractor. Refer to Figure 6 for correct

hardware.

2. Secure reinforcement brackets to mid-mount

bracket with cap screws (27), flat washers (29), and

hex nuts (28).

3. Secure to rear brackets with cap screws (25), flat

washers (29), and hex nuts (28).

Figure 6 Reinforcement bracket assembly

Figure 7 Reinforcement bracket assembly to mid-mount bracket & rear bracket

4. 1000581 Crossmember bracket

5. 1000594 Right reinforcement bracket

6. 1000595 Left reinforcement bracket

24. 307301 M12–1.75P x 40mm Cap screw

25. 58515 M12–1.75P x 45mm Cap screw

26. 58516 M12–1.75P x 50mm Cap screw

27. 307302 M12–1.75P x 90mm Cap screw

28. 307813 M12 x 1.75 Hex nut

29. 57811 1/2 Extra thick flat washer