Instruction manual

ASSEMBLY
-13-
Figure 12. Pulley and V-belt alignment.
Figure 13. Dust port mounting holes.
4. Halfway between the two pulleys, lightly
squeeze each side of the belt together to
check the tension.
Belt too loose? If each side of the belt
squeezes toward each other more than
1
⁄2",
increase the tension by repeating steps 2
and 3.
DO NOT over-tighten the belt! Do not use
pry bars or any other device to force the
motor down as this may over-tighten the
belt, which may damage the balance of the
motor shaft or bearings and increase the
wear of the power transfer components.
5. Check the V-belt pulley alignment. Minor
adjustments may be made by loosening the
pulley setscrew and sliding the pulley along
the shaft. See Figure 12 for details.
Dust Port
Using the (4) phillips head screws from the hard-
ware bag, attach the dust port over the dust
chute at the mounting holes shown in Figure 13.
Installing Fence
3. Locate the threaded hole on the back of the
infeed side of the fence and install the
fence tilt knob into the fence.
Figure 14. Installing key into fence support.
1. The fence support key has a roll pin fitted in
the center. Install the key into the fence
support keyway and fit the roll pin into the
provided hole. Figure 14 shows the key
installed correctly.
2. Get a friend to help you lift and place the
fence on this support.
Do not slide the fence across the outfeed
table. Scratching will result.
NOTICE
Key
Fence
Support