Operating instructions

GENERAL
INFORMATION
To ensure you get the very best from your new Worcester
Danesmoor oil boiler, please read these notes and instructions
carefully.
ELECTRICAL CONNECTION
The electrical supply to this appliance must satisfy the latest
edition IEE wiring regulations and any local regulations which
apply.
The mains supply to the boiler should be fed via a circuit
breaker incuding earth leakage protection.
The mains supply for your Danesmoor boiler is 230 volts
AC-50Hz.
Your boiler must be earthed and protected by a 5-amp fuse to
BS1362.
VENTILATION AND AIR SUPPLY
Air for the boiler is supplied via the balanced flue terminal,
and no other air supply is required, except for ventilation if the
boiler is installed in a cupboard or compartment.
ROUTINE MAINTENANCE
It is essential that your boiler is installed and serviced by a
competent heating engineer, and Worcester will be pleased to
arrange regular servicing and a comprehensive maintenance con-
tract.
Alternatively, the Oil Firing Technical Association for the
petroleum industry (OFTEC) will gladly advise you of engineers
trained by and registered with OFTEC.
Servicing should be carried out at least once a year for boilers
which burn 28-second kerosene.
The service engineer should have access to the property to
check for system faults and reset / replace electrical safety devices.
WARNING NOTE: Your boiler is serviced and repaired
externally. External equipment operated at 230 volts should not be
serviced or repaired under adverse weather conditions.
3