Operating instructions

DANESMOOR WM 12/19
HEAT SYSTEMS
HEATING
ADVANCE
OFF
TWICE
ONCE
ON
OFF
TWICE
ONCE
ON
SELECT LOCK SET? YES SELECT
PM
TUE
HOT
WATER
ADVANCE
SERIAL NUMBER
Your boiler serial number and model number should always
be quoted in any contact with Worcester. This will help identify
spare parts and also avoid confusion and delays during any service
call-out.
You will find the serial number on the front of the control
facia as shown in fig.1, and access can be gained by removing the
cabinet. Remove the cabinet by pulling the bottom forwards to
release the ballstuds, lift the cabinet upwards and slide forwards to
remove from the appliance.
TECHNICAL INFORMATION
The Worcester Danesmoor Wall Mounted oil-fired pressure-
jet boiler can provide both domestic hot water and full central
heating, with outputs ranging from 12kW to 19kW (41,000 to
65,000 Btu/h). Domestic hot water must be supplied via a con-
ventional indirect hot-water system, utilising an indirect double-
feed cylinder.
Your boiler is supplied pre-wired and may be fitted with a
facia mounted programmer (sold separately).
(See Fig. 1.)
(a) Switch on the electrical mains supply to the boiler and the
POWER ON lamp in the control facia will light up.
(b) Ensure that any external controls connected to the boiler, such
as a room thermostat, are on a high setting.
(c) If a programmer is fitted, set it to the correct time of day and
position the selectors to ON.
HOW TO START YOUR
BOILER
Fig. 1. Control Facia
Temperature Control Knob
Lockout Indicator Light
Mains Power Indicator Light
Optional Programmer
4
Manual Reset Overheat Thermostat Button
Lockout Reset Button
Duct Manual Reset Thermostat Button
Serial Numbers