Workrite Cascade Assembly Instructions for 2-Leg Counterbalance Workcenters #1500213- Rev B
Workrite Cascade Workcenter - Assembly Instructions A C List of Parts, grouped by carton B Cascade Base Assembly Qty: 1 Worksurface (size and shape differ) Qty: 1 D Cascade Feet Qty: 2 E F ! Cascade Bracket Qty: 2 #M4 × 10 mm Sheet Metal Screw Qty: 8 G #12 × ¾" Pan Head Laminate Top Screw Qty: 12 H #8 × ⅝" Pan Head Screw Qty: 6 I Cable Loops Qty: 1 #M8 × 14 mm Socket Head Machine Screw Qty: 12 CAUTION! Do not remove the Safety Tags until instructed to do so! DO NOT activate the Manual Rele
Workrite Cascade Workcenter - Assembly Instructions 1 a Verify that you have all the hardware and tools needed for the assembly. Check your cartons against the list on page 2 to verify that you have all the parts needed.
Workrite Cascade Workcenter - Assembly Instructions 3 Lock Legs into their vertical position a Use the 5 mm Allen Wrench to attach four #M8 × 14 mm Socket Head Cap Screw (F) to the outer leg mounts at the base of both legs. b Note: You may need to rotate the Counterbalance Adjustment Rod to be flat so you can more easily access the hole behind, to insert and tighten the screw. c Use the 5 mm Allen Wrench to tighten the four pre-installed Socket Head Cap Screws at the inner leg mounts on both legs.
Workrite Cascade Workcenter - Assembly Instructions 5 Center Base on Worksurface ! If you have a Workrite worksurface skip to step 6 a b c d If you do not have a Workrite worksurface: Align the Base Assembly (B) from the back on the bottom side of your worksurface (A). 24” worksurfaces are 2.8” from back, 30” worksurfaces are 5.8” from back. Center the Base Assembly left to right.
Workrite Cascade Workcenter - Assembly Instructions 5 Attach the Manual Release Do not remove the safety tag or activate the Manual Release Trigger. Serious injury or damage may occur! a DO NOT ACTIVATE MANUAL RELEASE! Activation of the Manual Release at this point may result in serious injury or damage to your workcenter! If you have a Workrite worksurface: Position the Manual Release over the pilot holes near front edge of worksurface.
Workrite Cascade Workcenter - Assembly Instructions 7 a Flip Table over then remove Safety Pin Carefully flip the Workcenter onto its feet. It is VERY important that the workcenter is on its feet prior to performing the next step! b Put a slight bit of pressure on the worksurface. c Remove the safety pins on both legs to unlock the counterbalance mechanism. d Remove the safety tag from the Manual Release.
Workrite Cascade Workcenter - Assembly Instructions 9 Adjusting the Counterbalance Mechanism Depending on the size of your workcenter and the items you place on it, you may require an adjustment to the counterbalance mechanism to find a setting that will adjust your worksurface with minimal human force required. all work item onto the worksurface to a Load have the approximate working weight on the a table. test the counterbalance.
