Fino™ Installation Instructions #1500154- Rev C
Fino Installation Instructions Parts A Light Fixture Qty: 1 B Transformer Qty: 0 or 11 C Rotating Magnetic Mounts Qty: 3 or 62 D Fixed Magnetic Mounts Qty: 4 or 82 I Cable Clips Qty: 2 or 42 E Rotating Wood Mounts Qty: 3 or 62 Max 2.
Fino Installation Instructions 1 Get to know your Fino a Determine which Fino you have purchased. There are 4 standard configurations. The information below list these configurations and their corresponding skus and parts layout. After mounting the Fino lights in step 2, proceed to the connection step listed for your configuration.
Fino Installation Instructions 2 Mount Fino: Determine if light will be affixed to a metal or wood cabinet and follow the appropriate directions below. If installing parent unit of daisy chain, be sure to position parent unit so that it can be connected to the additional unit with its supplied jumper cable. Be sure to position daisy-chained unit so that it can be connected to the previous unit with its supplied jumper cable.
Fino Installation Instructions 3 a b c d Connect Stand-alone units without Occupancy Sensor: BEFORE PLUGGING INTO WALL connect transformer to light Connect transformer (B) to larger diameter hole at either end of Fino light (A). Use Cable Clips (I) as needed to secure power cord. Plug power cord into transformer (B). Plug power cord into wall. Position light away from your eyes, and turn on.
Fino Installation Instructions Connect Daisy Chain Parent Unit without Occupancy Sensor (OCC): BEFORE PLUGGING INTO WALL connect Transformer and additional lights a Remote Remote 5 c Connect transformer (B) to larger diameter hole at either end of Fino unit. ! Local a b Turn over Fino and confirm Local setting. Local Use Cable Clips (I) as needed to secure cord. CAUTION – Setup Fino BEFORE plugging into wall socket. Maximum number of daisy chain lights should not exceed chart on page 8.
Fino Installation Instructions Connect Daisy Chain Parent Unit with Occupancy Sensor (OCC): BEFORE PLUGGING INTO WALL connect Transformer, OCC, Master Switch, and all lights Set the switch on the back of the Fino unit to the “Remote” position to allow it to be controlled by the Master Switch. The Remote position is the one closest to the edge of the Fino. b c d e Use Cable Clips(I) as needed to secure cord.
Fino Installation Instructions 7 a b c d Connect Daisy Chain Jumper units: BEFORE PLUGGING INTO WALL connect all lights Connect later Finos together using 2-prong jumper cables or Connector (M). Use Cable Clips(I) as needed to secure cord. Plug power cord into Transformer. Plug power cord into wall. Position light away from your eyes, and turn on.
