Installation Sheet
6
Maintenance and Cleaning Instructions
IMPORTANT: The dryer may collect lint and debris that is naturally present in the air. Excessive build
up of lint and debris can damage the motor and heating element. The dryer should be cleaned on a
routine schedule to maintain the dryer in good operating condition With light to moderate wash room
trafc, cleaning once a year is recommended. If wash room trafc is high, cleaning every 6 months is
recommended.
To clean the hand dryer:
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer.
3. Use a soft-medium bristle paint brush to clean lint, dust and debris from the air intake slots, and the motor’s exterior.
4. After cleaning, reassemble the dryer cover using the security hex key supplied to turn the cover mounting screws
counter-clockwise and tight until snug. Do not over tighten.
HEPA Filter Replacement
(for models including HEPA lters)
Your specic model may include a high efciency particulate absorbtion
(HEPA) lter to remove a minimum of 99.97% of contaminants at 0.3
microns in size or larger.
The service life of a HEPA lter depends on the environment in which the
dryer is installed and frequency of use. High trafc washrooms or high
usage will require more frequent inspection and replacement of the HEPA
lter. The HEPA lter should be inspected at least four times per year in
washrooms with light to moderate trafc and normal environments. In
environments with excessive, dust and debris or in washrooms with high
trafc, inspection of the HEPA lter is recommended on a monthly basis.
When visual inspection of the HEPA lter shows excessive buildup of lint,
dust and debris, the lter should be replaced.
Examining and changing a HEPA lter regularly keeps hand dryers
working efciently. Operating a hand dryer with an excessively dirty or
clogged lter can damage your machine.
The HEPA lter cannot be cleaned and re-used. Do not clean the HEPA
lter or allow it to come into contact with water.
To inspect or replace the HEPA lter:
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws
clockwise to remove the cover from the dryer.
3. Removing and replacing the HEPA lter is easily done by sliding the
lter in its mounting track on the motor cap.
4. After replacing the HEPA lter, reassemble the dryer cover using the
security hex key supplied to turn the cover mounting screws counter-
clockwise and tight until snug. Do not over tighten.
5. Reconnect the power source.
Figure 2
Models with HEPA Filter
HEPA Filter
Models not including HEPA Filters
Coarse Particulate Filter