Specification

CAUTION:
Be certain that no bare wire strands are exposed outside of the wire connectors.
Disconnect power at main circuit breaker to prevent possible injury from electrical shock.
To reduce the risk of fire, electric shock, or personal injury, mount to outlet box marked (a) and
use mounting screws provided with the outlet box.
Warning - to reduce the risk of electric shock, this fan must be installed with an isolating wall control/switch.
Warning - to reduce the risk of fire, electric shock, or personal injury, mount to outlet box marked (a) acceptable
for fan support of 22.7kg(50lbs) or less, and use mounting screws provided with the outlet box.
“Suitable for use with solid-state speed controls” or equivalent.
ATTENTION :
Assurez-vous qu’aucun brin métallique dénudé n’est exposé en dehors des capuchons de connexion.
Coupez le courant au disjoncteur principal pour empêcher les blessures résultant d’un choc électrique.
Pour réduire les risques d’incendie, d’électrocution ou de blessure, fixez à une boîte de sortie de courant
portant la mention (a) et utilisez les vis fournies avec la boîte de sortie de courant.
Avertissement - Pour réduire le risque d’électrocution, ce ventilateur doit être installé avec une
commande/interrupteur mural(e) isolé(e).
Avertissement - Pour réduire les risques d’incendie, d’électrocution ou de blessure, installez sur une
boîte de sortie de courant portant la mention (a) «capable de supporter un ventilateur de 22,7 kg (50 lb)
ou moins» et utilisez les vis de montage fournies avec la boîte de sortie de courant.
«Adapté à un usage avec les dispositifs de contrôle de la vitesse transistorisés» ou équivalents.
PRECAUCIÓN:
Asegúrate de que no haya cables pelados expuestos fuera de los conectores de cables.
Desconecta la electricidad en el cortacircuitos principal para evitar posibles lesiones por descargas eléctricas.
Para reducir el riesgo de incendio, descarga eléctrica o lesiones personales, móntalo en una
caja eléctrica marcada como (a) y usa los tornillos de montaje que vienen con ella.
Advertencia - para reducir el peligro de descarga eléctrica, este ventilador debe instalarse con un
interruptor/control de pared aislante.
Advertencia - para reducir el peligro de incendio, descarga eléctrica o lesiones personales, instala en una
caja eléctrica clasificada como (a) apropiada para sostener ventiladores de 22.7 kg (50 lbs) o menos, y usa
los tornillos de montaje que vienen con ella.
“Adecuado para usarse con controles de velocidad de estado sólido” o equivalentes.
NOTICE:
Before using this product and doing maintenance, please read these instructions carefully
and save them for future use.
This product is suitable for use with solid-state speed controls.
The installation is to be in accordance with the national electrical code, ANSI/NFPA 70 and local codes.
After being wired, the ungrounded wire and grounded/grounding wire must be separated in two side of the
outlet box.
The splices, after being made, should be turned upward and pushed carefully up into the outlet box.
The remote controller is suitable for ceiling fan use.
This unit is packed completely for ceiling fan use.
This unit weighs 7.36 kg.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
2