Operation Manual

Jigsaw EN
11
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ALWAYS WEAR A DUST MASK
INTENDED USE
The machine is intended for sawing wood,
plastic, metal and building materials while
resting firmly on the workpiece. It is suitable
for straight and curved cuts with mitre angles
to 45°. The saw blade recommendations are to
be observed.
ASSEMBLY AND OPERATION
Action Figure
Blade Installation See Fig. A1
Blade Removing See Fig. A2
Variable Speed Control
(Only for WX478 WX479)
See Fig. B
Pendulum Function See Fig. C
ON/OFF Switch See Fig. D
Lock-On Button See Fig. D
Straight Cut and Curve Cut
See Fig.
E1,E2
Bevel Cut See Fig. F,G
Plunge Cut See Fig. H
Parallel Guide (Only for
WX478 WX479)
See Fig. I1,I2
Blade Storage (Only for
WX478/WX479)
See Fig. J
Vacuum Adaptor (Only for
WX478/WX479)
See Fig. K
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.