Assembling & Installation Instructions

ManualsBrandsWrought Studio ManualsCandle-Style ChandeliersBeldale 5 - Light Candle Style Classic / Traditional Chandelier

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for

installation.

3. Slide the electrical wires through the tubes(D)/(C)/(B) and

canopy(A).

4. Raise the tube (D) to top pipe thread of lamp body(E), by turning it

clockwise until tight. Raise the tube (C)/(B) and canopy(A) to the

pipe thread in order, then by turning it clockwise until tight.

5. Attach the mounting screw part way into the side hole of the single

bar, then lock it securely with hex nut until becoming. Attach the

single bar to the junction box using two box screws as shown. The

side of the single bar marked “GND” must face out. The junction

box is not included.

6. While holding the fixture lamp towards the ceiling, connect the

electrical wires as Shown in Fig.2, making sure that all wire nuts are

secured. You may have to wrap the connections with electrical tape.

If your outlet has a ground wire (green or bare copper), connect the

fixture ground wire to it. Otherwise connect fixture’s ground wire

directly to the Mounting plate with the green screw provided. After

wires are connected, tuck them carefully inside the Junction Box.

7. Raise the canopy (A) on to the Junction box, aligning screws on

single bar with mounting holes in canopy and lock it securely with

the column nuts.

8. Install the light bulbs(Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED

WATTAGE!

Your installation is now complete. Return power to the

junction box and test the fixture.

Columnnut

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Thank you for purchasing our product.

Need assistance with parts or assembly? Please call customer service

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS FIG.1 The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area.