Specifications

MOUNTING
The Sidewinder SW720 camera should normally be mounted in an upright orientation, as
shown above. The camera may also be mounted upside down if desired, but a cover of
some sort should be placed over the bottom of the camera, extending out to about 6
inches past the camera all around, to prevent debris, dirt or snow and ice from
accumulating on the bottom of the camera housing, since the conical shaped profile of the
camera will no longer be able to naturally shed material to the sides. The camera may
NOT be mounted with the base facing horizontally.
Figure 2
The base of the Sidewinder SW720 camera has four 5/16-18 screw holes that are equally
spaced, 90 degrees apart, on a 4.75” diameter circle, as shown in figure 2. If mounting
screws other than those provided with the camera are used, the length of the mounting
screws should be selected so that the screws penetrate no more than 0.75 inches into the
base.
SW720 Series 24VAC WTI ~ Page 11 of 23