User Manual

- 7 -
HOT AIR GUN COOL DOWN SLEEP FUNCTION
When the hot air gun is placed in the side holder or the
vertical position in the upright tower holder (see page 3), it will
automatically go into cool down mode. When the hot air gun
is initially returned to either of these holders, the air flow may
increase noticeably while the hot air gun is cooling down and going
into sleep mode. This is a safety feature built into the unit.
If the hot air gun is placed in the horizontal position on the upright
tower holder (see page 3), the hot air gun will NOT go into the cool
down sleep mode. This position on the holder should only be used
for short periods of time when you are in the middle of a specific
project.
TEMPERATURE CONVERSION
1. Ensure the soldering iron and the hot air gun are in their respective
holders and that the unit is off.
2. Turn on the power switches for both the hot air gun and soldering
iron on the front of the unit.
3. With both of those switches on, press and hold the right Function
setting button (also known as the ▲ Hot Air Temperature Button)
while turning on the unit with the main switch on the back.
4. The top display will say C - C or F - F to indicate that the unit is
now in Celsius or Fahrenheit respectively.
MUTE / UNMUTE FUNCTION
The unit beeps when buttons are pushed, knobs are turned and
when it goes into sleep mode.
1. Ensure the soldering iron and the hot air gun are in their respective
holders and that the unit is off.
2. Turn on the power switches for both the hot air gun and soldering
iron on the front of the unit.
3. With both of those switches on, press and hold the left Function
setting button (also known as the ▼ Hot Air Temperature Button)
while turning on the unit with the main switch on the back.
4. The bottom display will say “on” or “off” to indicate that the sounds
for the unit are unmuted or muted accordingly.