Manual

Xerox 4595 Copier/Printer System Administration Guide
8-108
8. Setups
Stamp Position-Left Center This feature allows you to fine tune exactly where on the left
center of the output that your stamp is printed. The selection
made here becomes the default setting when Left Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-100 in1 mm
increments.
Stamp Position-Center This feature allows you to fine tune exactly where on the center of
the output that your stamp is printed. The selection made here
becomes the default setting when Center is selected for the
Stamp Position on the Annotation screen (Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-200 in 1 mm
increments.
Stamp Position- Right
Center
This feature allows you to fine tune exactly where on the right
center of the output that your stamp is printed. The selection
made here becomes the default setting when Right Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-100 in 1 mm
increments.
Stamp Position- Bottom
Left
This feature allows you to fine tune exactly where on the bottom
left of the output that your stamp is printed. The selection made
here becomes the default setting when Bottom Left is selected
for the Stamp Position on the Annotation screen (Output
Format tab).
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-100 in 1 mm
increments.
Stamp Position- Bottom
Center
This feature allows you to fine tune exactly where on the bottom
center of the output that your stamp is printed. The selection
made here becomes the default setting when Bottom Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-200 in 1 mm
increments.