Manual

Xerox 4595 Copier/Printer System Administration Guide
2-8
2. Configuration
h. Configure TCP/IP - Subnet Mask and TCP/IP - Gateway
Address as shown above.
NOTE 1: Enter addresses in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0 to
255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx
cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However, you
cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address, enter
"0.0.0.0."
4. Select Close repeatedly until the System Settings screen is
displayed.
5. Select Exit.
6. After the machine is restarted, print out the Printer Settings
List to confirm that the SMB port is enabled.
NOTE: If using the NetBEUI protocol, select NetBEUI as the
protocol used by SMB for the port configuration using CentreWare
Internet Services.
Configure the SMB as necessary. Refer to “SMB” on page 3-8 for
the SMB configuration.