User's Manual

Standard Finisher Plus
The Standard Finisher Plus serves as an interface to transfer paper between the print
engine and any third-party, Document Finishing Architecture (DFA) device attached to
the machine.
Note
The Standard Finisher Plus requires the either the Interface Module (for D110/D125
configurations) or the Interface Cooling Module (for D136 configurations). The Standard
Finisher Plus is not available with the D95 Copier/Printer configuration.
Third-Party Finishing Devices (D110/D125/D136 configurations)
Additional third-party, Document Finishing Architecture (DFA) devices are also available
for your machine. Information on these DFA devices can be obtained by contacting your
Xerox sales representative.
Note
All third-party, DFA devices require the Interface Module (for D110/D125 configurations)
or the Interface Cooling Module (for D136 configurations), and they also require the
Standard Finisher Plus. DFA devices are not available with the D95 Copier/Printer
configuration.
User Guide1-12
Product Overview