User's Manual

013-110
Cause: The transport exit sensor in the Finishing Transport did not switch OFF within
a specified amount of time.
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
013-910
Cause: Paper jam at the transport in sensor (Finishing Transport)
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
013-911
Cause: Paper jam at the transport exit sensor (Finishing Transport)
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
Finishing Transport fault codes
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
051-100
Cause: Paper jam
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
User Guide18-38
Standard Finisher Plus