User's Manual

Cause and RemedyFault code
Cause: Numerical value operation error occurred as a value exceeding the value
limit of the printer was used in the print data.
Remedy: Check the print data.
116-740
Cause: There are too many paper margin values for the HP-GL/2 effective
coordinate area.
Remedy: Reduce the paper margin values, and instruct it to print again.
116-747
Cause: There is no plot data in the HP-GL/2 print data.
Remedy: Check the print data.
116-748
Cause: Job cancelled because the specified font was unavailable.
Remedy: Install the font or set up a font replacement on the print driver side.
116-749
Cause: There was a problem with parameters in the JBIG data. They were
automatically edited.
Remedy: If any problem occurs in job result, try to process the job again.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-790
Cause: There is a problem with the document attached to the received mail.
Remedy: Check the attached document.
116-780
Cause: A malfunction occurred in the machine.
Remedy: Power-cycle the machine. If the machine error is not fixed by performing
the relevant remedy, contact the Customer Support Center.
124-345
124-346
124-347
124-348
124-349
Cause: Communication error between the printer and the controller. Error detected
by the printer.
Remedy: Remove and reinsert the cable connection between the printer and the
controller. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-210
Cause: Detected a communication error between the printer and the controller.
Remedy: Remove and reinsert the cable connection between the printer and the
controller. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-211
Cause: Detected an internal print check error by the controller.
Remedy: Remove and reinsert the command/video cable between the controller
and the printer. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-212
Cause: Detected a mismatch with the software version of the controller.
Remedy: Contact the Customer Support Center for information and/or instructions
to remedy the problem.
127-213
10-23Xerox
®
D110/D125/D136 Printer
User Guide
Problem solving