All in One Printer User Manual
7+('2&80(17&203$1<
DC230LP Windows NT
®
4.0 TCP/IP Quick Install
Page 2 of 4
e)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
7. Enter the Subnet Mask:
a)
Press [] until
displays.
b)
Press []. displays.
c)
Use the [] or [] key to select the
first digit of the Subnet Mask for your
network.
d)
Press [] to move to the next digit.
Repeat this procedure to enter the
entire Subnet Mask.
e)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
8. Enter the Broadcast Address:
Note: Broadcast Address is where all the host
bits are set to either zeros (0) or ones (1).
Default Gateway
(your entry)
>
Subnet Mask
(current entry)
>
Subnet Mask =
(current entry)
Subnet Mask
(your entry)
>
a)
Press [] until
displays.
b)
Press []. displays.
c)
Use the [] or [] key to select the
first digit in the Broadcast Address.
d)
Press [] to move to the next digit.
Repeat procedure to enter the entire
Broadcast Address.
e)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
9. Enter the Printer (Host) Name:
Note: It is recommended that the Printer (Host)
Name be the same as your Share Name.
a)
Press [] until
displays.
b)
Press []. displays.
c)
Press [] repeatedly until the cursor
reaches the last character. A tone
sounds indicating when the last
character has been reached.
Broadcast Addr
(current entry)
>
Broadcast Addr =
(current entry)
Broadcast Addr
(your entry)
>
Printer Name
(current entry)
>
Printer Name =
(current entry)
b)
Press []. displays.
c)
Press [] until the required setting
displays .
d)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
6. Enter the Gateway Address:
a)
Press [] until
displays.
b)
Press []. displays.
Note: Use zeros to supplement each address
segment if fewer than 3 digits are used; e.g.,
13.252.25.08 = 013.252.025.008.
c)
Use the [] or [] key to select the
first digit in the Gateway Address.
d)
Press [] to move to the next digit.
Repeat this procedure to enter the
entire Gateway Address.
RARP =
(current entry) *
RARP =
(required entry)
RARP
(your entry)
>
Default Gateway
(current entry)
>
Default Gateway =
(current entry)