Multifunction Printer User Guide

Configuring the Network Address
Phaser® 8510/8560MFP Multifunction Product
2-6
Dynamic Methods of Setting the System’s IP Address
Set the system’s IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
■ DHCP
■ CentreWare IS
■ AutoIP
Enabling DHCP on the System
Verify that the system DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
Note: To determine the system’s IP address, select System Identification. On the control
panel, press the System button, select
Information, press the OK button, select System
Identification
, and then press the OK button to view the system’s IP address.
See also:
Control Panel Features on page 1-8
Information Required for Manual IP Addressing
Information Comments
Internet Protocol (IP) address of the system Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
Network Mask If you are unsure, leave this blank; the system
chooses an appropriate mask.
Default Router/Gateway address Router address is required to communicate with
the host device from anywhere other than the
local network segment.