User's Manual

Protocol Control
System Administrator Guide
3-6
Protocol Control
This section includes:
■ HTTP on page 3-6
■ TCP/IP on page 3-6
■ Port 9100 on page 3-7
■ LPR on page 3-7
■ IPP on page 3-8
■ SNMP on page 3-8
■ Email Server on page 3-9
■ MaiLinX Remote Printing on page 3-10
■ MaiLinX Alerts on page 3-11
See also:
Discovery Protocols on page 2-5
All network protocols, including network printing, printing services, printer discovery, and
management protocols can be enabled or disabled on the printer. If a protocol is enabled, you
can set configuration parameters.
Note: To secure protocols, disable any protocols you are not using. This prevents
unauthorized access through applications that use these protocols. For example, if you want to
use IPP for a secure printing channel, disable the other printing protocols, Port 9100 and LPR.
HTTP
By default, HTTP is enabled. For information on disabling HTTP, contact Xerox Technical
Support at www.xerox/office/support
.
See also:
About HTTP, HTTPS, and SSL/TLS on page 4-3
TCP/IP
To change TCP/IP settings:
1. Launch your web browser.
2. Enter your printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the Protocols folder on the left sidebar.
5. Select TCP/IP.
6. If prompted, enter your Admin or Key User name and password.
7. In the BOOTP/DHCP box, select one of the following:
■ On: The printer issues BOOTP and DHCP requests on startup.
■ Off: The printer does not issue BOOTP or DHCP requests on startup.