Operation Manual

Gesetzliche Bestimmungen zum Faxbetrieb
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Sicherheit und gesetzliche Bestimmungen
314
Kanada
Hinweis: The Industry Canada label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The Department does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users must make sure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect the equipment.
Users should make sure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe systems, if present, are connected together.
This precaution may be particularly important in rural areas.
ACHTUNG: Users should not attempt to make such connections themselves, but should contact
the appropriate electric inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on
an interface may consist of any combination of devices subject only to the requirement that the sum
of the Ringer Equivalent Numbers of all of the devices does not exceed 5. For the Canadian REN value,
please see the label on the equipment.
Europa
Richtlinie zu Funkanlagen und Telekommunikationseinrichtungen
Das Faxmodul wurde gemäß der Entscheidung 1999/5/EG des Rates europaweit zur Anschaltung als
einzelne Endeinrichtung an das öffentliche Fernsprechnetz zugelassen. Aufgrund der zwischen den
öffentlichen Fernsprechnetzen verschiedener Staaten bestehenden Unterschiede stellt diese Zulassung
an sich jedoch keine unbedingte Gewähr für einen erfolgreichen Betrieb des Geräts an jedem
Netzabschlusspunkt dar.
Falls beim Betrieb Probleme auftreten, zunächst den Fachhändler kontaktieren.
Das Gerät entspricht ES 203 021-1, -2, -3, einer technischen Spezifikation für Endgeräte für analog
geschaltete Fernsprechnetze im europäischen Wirtschaftsraum. Der Ländercode kann vom Benutzer
selbst eingerichtet werden. Einzelheiten hierzu enthält die Kundendokumentation. Der Ländercode
sollte vor Inbetriebnahme des Geräts im Netzwerk eingerichtet werden.
Hinweis: Obwohl bei dem Gerät sowohl Ton- als auch Pulswahl verwendet werden kann, wird eine
Einstellung auf Pulswahl empfohlen. Mit Pulswahl wird ein zuverlässigerer und schnellerer
Rufaufbau erzielt. Modifikationen am Gerät, der Anschluss externer Steuerungssoftware oder
einer externen Steuereinrichtung, die nicht von Xerox genehmigt wurde, führen zum
Ungültigwerden der Produktzertifizierung.