Operation Manual

Bypass Tray
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Paper and Media
228
Loading the Bypass Tray
Your device alerts you if the Bypass Tray is selected for a job and the media requested does not match
the media currently loaded. It also warns you if the tray runs out of paper during a job.
1. Make sure the tray is in the down position. For larger
media, use the tray extension.
2. Place the media on the tray. Locate the media to the
right edge.
• Load pre-printed paper and labels face-up and
with the top towards the front of the device.
• Load hole punched paper with the holes on the
right.
• Load transparencies face-up with the white strip
on the right.
For information about loading tabs, refer to Media Types on page 233.
Paper must not be loaded above the maximum fill line.
3. Make sure that the guides just touch the paper.
The paper settings for the tray are displayed on the
touch screen.
The tray detects the position of the side guide to
determine the size of the media.
4. Confirm or change the settings, as required.