Operation Manual
Copy Options
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Copy
46
2 Sided Copy
The device provides options to make one or two-sided copies from one or two-sided originals using
either the document feeder or the document glass. The options are:
• 1 > 1 sided use this option if your originals are printed on one side and you want single-sided
copies.
• 1 > 2 sided use this option if your originals are printed on one side and you want 2-sided copies.
You can also select the Rotate Side 2 button to have the second page rotated by 180
o
.
• 2 > 2 sided use this option if you want to make two sided copies from two-sided originals. You can
also select the Rotate Side 2 button to have the second side(s) rotated by 180
o
.
• 2 > 1 sided this option will make one-sided copies from two-sided originals.
Note: If using the document glass to scan originals, the device displays a message when ready to
scan side 2. Continue scanning until all sides have been scanned.
Copy Output
The most commonly used Copy Output options are selected directly from the Copy tab. The options
available are dependent on the finishing device and kits installed. For further information, refer to
Finishing Devices on page 49.
Use More... to access all the options. When you have finished programing your options, select Save to
save your selections and exit.
None
This option is selected if no finishing is required for the copy output.
Collation
Select the Collation option required. The options are:
• Collated sorts your copies into sets 1,2,3 1,2,3 1,2,3.
• Uncollated sorts your copies into stacks 1,1,1 2,2,2 3,3,3.
Stapled
The stapling options available are dependent on the finishing device available and the configuration
setup. For information about the available options, refer to Services and Options on page 12 of Getting
Started.
• 1 Staple select this option and then select the corner
required for the staple. A single staple will be
positioned in the corner selected.
• 2 Staple select this option and then select the edge
required for the staples. Two staples will be positioned
along the edge selected.