Operation Manual

Job Assembly
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Copy
64
7. Load the second segment originals and press Start.
8. Repeat these steps until all segments of your job have been programmed and scanned.
9. After the last segment has been scanned, select End Build Job to indicate you have finished
scanning and the job will be processed and printed.
Sample Job
When copying a large number of sets, use the Sample Job feature to review a proof copy to ensure that
all the print settings are correct before printing the remaining sets.
1. Select the Sample Job button on the Job Assembly tab.
2. Select the On button and the Save button.
3. Load the originals in the document feeder and
program the job requirements. Enter the total quantity
required and press the Start button.
One copy set of the job, the Sample Job, is printed.
The whole job is held in the Job List.
4. Access your job by selecting the Job Status button.
The job has the status Held: Sample Made.
5. Select the job in the list.
If the Sample Job is acceptable, select Release. The programmed number of sets will be produced.
If the Sample Job is unacceptable, select Delete and Delete Job to confirm. Your job will be
deleted from the list.