Operation Manual

Output Format

WorkCentre™ 5735/5740/5745/5755/5765/5775/5790

Copy

4. Select the Reading Order required for the finished output, either Left to Right or Right to Left.

Note: This option will not be displayed if it has not been enabled in Tools. Refer to Set Copy

Defaults on page 263 of Administration and Accounting.

5. If the High Volume Finisher with Booklet Maker is installed, select the finishing option required:

• Folded & Stapled will staple and fold the output

along the center margin to produce booklets.

• Folded Only will fold the output along the center

margin to produce booklets.

6. Select the Original Input, either 1 Sided Originals or

2 Sided Originals depending on the originals being

scanned.

7. Select Save to confirm your selections.

8. Load your originals into the document feeder and select Start to run the job.

Covers

Covers enables blank or printed pages to be added to the front, back or front and back of your set. This

option is also used to add a cover to a booklet. The covers can be a different media to the rest of your

job.

Note: Covers cannot be used with Auto Paper Supply, a paper supply must be specified.

Use the following instructions to program Covers:

1. On the Copy tab, select the paper you want to use for the main body of the job.

2. Load the media to be used for the covers into another paper tray, ensuring that it is in the same

size and orientation as the paper you are using for the main body of your job.

Note: For further information about loading media, refer to Paper and Media on page 219.

Update the Paper Settings screen and Confirm your selections.

3. Select Covers from the Output Format tab.

4. Select the Covers Option required:

•No Covers

• Front Cover Only adds a blank or printed cover to

the front of the document.

• Back Cover Only adds a blank or printed cover to

the back of the document.

• Front & Back Covers adds a blank or printed cover

to the front and back of the document. The

printing and paper supply options can be programmed individually for each cover.

• Booklet Cover used to add a cover to a booklet if using the Booklet Creation option.