Owner manual

Fig. 2

At the Command prompt on the DOS screen type: “telnet” the IP

address of the SMTP server with port number “25”. Then press

Enter. The entry should display as in this figure.

Fig. 5

Type in “mail from: your e-mail address” and press Enter. The

entry should look something like this figure.

Fig. 1

Open a DOS Command Prompt window.

Note 1: This is a suggested testing procedure that requires

a working knowledge of DOS, and a program called

“Telnet .exe” or “Telnet.com”.

Note 2: If the echo function of your telnet program is not

enabled, you will not see what you type at the DOS

command prompt. Please type slowly and carefully.

Fig. 4

If you received the ready message similar to the one in this figure,

continue to the next step.

Fig. 3

If you received a Connect failed, repeat step Fig. 2 again. If it

continues to fail, please contact your IT Administrator or your Internet

Service Provider to obtain a working SMTP Server Address.

SMTP Server Verification - 1 of 2

PAGE 1
Note 1: This is a suggested testing procedure that requires a working knowledge of DOS, and a program called “Telnet .exe” or “Telnet.com”. Note 2: If the echo function of your telnet program is not enabled, you will not see what you type at the DOS command prompt. Please type slowly and carefully. Fig. 1 Open a DOS Command Prompt window. Fig. 2 At the Command prompt on the DOS screen type: “telnet” the IP address of the SMTP server with port number “25”. Then press Enter.
PAGE 2
Quick Start Guide SMTP Server Verification Fig. 6 Type in “rcpt to: your e-mail address” and then press Enter. The entry should look something like this figure. Fig. 7 Type “data” and press Enter. To end the e-mail type (.) and press Enter. It can take a few minutes for the e-mail message to be delivered to the Inbox of your e-mail account. Once you have received the e-mail, please continue the setup with the Internet Faxing / iFax Part 1 of 3 pamphlet.