Model No.
1-2 3-4 Industry Canada Notice 5 6 8 9 10-12 13-15 16-17 18-25 26 27 28 29
Keep Dry – Do not operate in a wet or moist condition.
Temperatures sufficiently high to cause burns may occur regardless of the control setting. Do not use on an infant or invalid or on a sleeping or unconscious person. Do not use on insensitive skin or on a person with poor blood circulation. Check the skin in contact with the heated area of the appliance frequently to reduce the risk of blistering. Do Not Crush – Avoid sharp folds. Do not use massager in close proximity to loose clothing or jewelry. Keep long hair away from massager while in use.
3
Caution 4
5
Industry Canada Notice ISED Statement English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
Industry Canada Notice RF Exposure Statement This equipment should be installed and operated with minimum distance 10cm between the radiator & your body. Cet équipement doit être installé et utilisé à une distance minimale de 10 cm entre le radiateur et votre corps. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions: 1.
7 8 9 3D heating section Waist massage section Bluetooth Music Speaker 8 9 8
63 9 9
Remove the chair parts out of carton including main unit and legrest (legrest is on the seat of main unit). 51.6 30.5 54.
Step 2: Install A on the main unit A on the legrest Connect the electrical connector: B1(on the legrest) and B2(on the main unit).
C on the legrest C C C 12 on the main unit
If an object is detected around the footrest, there will be the following caution! 13
14
15
1 2 3 4 7 5 6 1. When you encounter any problems and need to stop the massage immediately, please press this button, and the massage chair will stop all actions. 2. User can adjust backrest recline by touching the icon. 3. User can adjust backrest incline by touching the icon. 4. User can adjust footrest incline by touching the icon. 5. User can adjust footrest recline by touching the icon. 6. The button for the footrest allows you to extend the length of the footrest. 7.
ON/OFF Button Touch screen (Main operation page) Touch keys AUTO 17
Press this key to start the massage chair. Backrest and footrest of the massage chair are automatically adjusted to the default angle. The remote control enters to the main operation page. Press this key again. Massage function stops. The massage mechanism, backrest and footrest restore to its original position. The massage chair is turned off.
‘Auto’ Massage 2. There are 15 massage modes to select from. After the selection, relevant massage starts. The remote control enters to the adjustment page. 3. The adjustment page. # $ $ % $ $ scanning). 5. Please sit as far back in the seat as possible with your head on the pillow during the scanning. Adjustment notes 1. 3D : Touch 3D to adjust 3D massage intensity ( 6 levels).
‘Manual’ Massage G H 2. There are 15 massage modes to select from. After the selection, relevant massage starts. The remote control enters to the adjustment page. 3. The adjustment page. # $ $ % $ $ scanning). 5. Please sit as far back in the seat as possible with your head on the pillow during the scanning.
Adjustment notes 1. 3D : Touch 3D to adjust 3D massage intensity(6 levels). 2. Strength : Touch Strength to adjust Kneading strength(5 levels). 3. Speed : Touch Speed to adjust Tapping speed(5 levels). 4. Width : Touch Width to adjust Rolling width(3 levels). 5. Spot : Touch Spot to activate spot massage. The massage roller will spot on the position it goes when user presses the button. Press again to cease spot massage. 6. Partial : Touch Partial to activate partial massage.
‘Special care’ Massage G H * J ; remote control enters to the adjustment page. Adjustment notes 1. 3D:Touch 3D to adjust 3D massage intensity ( 6 levels). * +; < = % > ? @ +; < ; % > ? 4. Intensity:Touch Intensity to adjust air massage intensity ( 5 levels ).
‘Air’ Massage G H 2. Touch Intensity to adjust the intensity of air massage ( 5 levels ). ‘Advanced’ Massage G H J massage starts: > + Z J @[ J J V \[ These 5 programs can be used at the same time.
Foot roller Touch foot roller to start foot roller function. Press again to cease foot roller function. 3D heating Touch 3D heating to start Calf heating function. Press again to cease 3D heating function.This function is designed especially for your shoulder and stomach. It can give you a 3D frontal heating experience. Lumber heating Touch Lumber heating to start Lumber heating function. Press again to cease Lumber heating function. Calf heating Touch Calf heating to start Calf heating function.
@ ` { # = #+ Press to enter the Zero Gravity position (the most relaxing and comfortable state of position). Press again to restore to the last position. This key cannot be effected under G H Settings ] # + %\ ^ ; V ? _ < < Bluetooth button Touch the Bluetooth icon can control the bluetooth on and off.
26
again.
28
Osaki Pro OS-3D Opulent 145W Upright：64.2" x 29.7" x 50.2" Reclined: 76.5" x 29.7" x 39.3" Gross Weight: Approx 276.1lbs Net Weight: Approx 239.
