Quick Start Guide

11
7. Packet Forwarder Configuration
UG63 has pre-installed multiple packet forwarders including Semtech UDP Packet Forwarder,
Chirpstack-Generic MQTT broker, LoRa Basic Station, etc. This section explains how to connect the
gateway to network servers.
Make sure the gateway connects to the network as shown in Section 6.
A. Go to “Packet Forwarder” → “General” page and click to add a network server.
B. Fill in the server information and enable this server.
C. Go to “Packet Forwarder” → “Radio” page to configure center frequency and channels. The channels
of the gateway and network server need to be the same.