User Manual

Appendix E. Agency Notices
102 iX104 User’s Handbook
RF eposure
Tests for SAR are conducted using standard operating positions
specified by the FCC with the tablet PC transmitting at its highest
certified power level in all tested frequency bands. Although the SAR
is determined at the highest certified power level, the actual SAR
level of the tablet PC while operating can be well below the
maximum value. This is because the tablet PC is designed to operate
at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a tablet PC model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the limit
established by the government-adopted requirement for safe
exposure. The tests are performed in positions and locations (e.g., at
the ear and worn on the body) as required by the FCC for each model.
(Body-worn measurements may differ among tablet PC models,
depending upon available accessories and FCC requirements). While
there may be differences between the SAR levels of various tablet
PCs and at various positions, they all meet the government
requirement for safe exposure.
This device was evaluated and shown to comply with FCC SAR
guidelines. Avoid covering or holding antennas when transmitting.
Antenna locations are shown in the following figure.
antenna locations