User Manual
Table Of Contents
- Contents
- 1 Getting Started 19
- 2 Using the iX104 33
- 3 Maintaining the iX104 73
- Welcome
- 1 Getting Started
- 2 Using the iX104
- Turning on the computer
- Turning off the computer
- Suspending and resuming operation
- Using the pen
- Using the joystick (the navigation control key)
- Changing the screen orientation
- Adjusting the screen brightness
- Docking the iX104
- Connecting devices
- Using the battery
- Programming hot keys
- 3 Maintaining the iX104
- A Troubleshooting
- B Using BIOS and AOS Functions
- C Glossary
- D Hardware Specifications
- E Agency Notices
- Index
Appendix A. Troubleshooting
iX104 User’s Handbook 83
Headphone or speaker volume is
too low.
• The volume may be in Mute mode or set too low. Follow the
instructions in “Adjusting headphone or speaker volume” on
page 50.
• Make sure the volume control in your audio software is set to
an audible level.
An external device is not working
with the computer.
The device may need to be enabled in the computer’s
configuration program (BIOS Setup). Contact your local help
desk or reseller.
The Status LED is red, continuous. • The computer is on, running under battery power, and the
charge level in the battery has reached a critical level. Plug
the computer into an AC/DC power source or install a
charged battery.
• The system has encountered a fault and is preventing
normal operation. Contact your local help desk.
The Status LED is red, blinking. The computer is powered on, running under battery power,
and the charge level in the battery is at a minimum warning
level. Plug the computer into an AC/DC power source or install
a charged battery.
Table 8 Troubleshooting (continued)
Problem Possible cause and solution