Use and Care Guide

Specifica�ons
** Actual parts are not limited on this list, contact XPOWER for ordering parts.
Parts List
- 5 -
Daisy Chain for X-2480A
XPOWER X-2480A Air Scrubber is daisy chainable with
a low 2.8 amp draw. The 12 amp on-board Circuit Breaker
allows two additional 2000 series units or other devices (total
additional amperage must be less than 9A) to run on one circuit
the same time. If the Auxiliary Outlet overloads (over 12A), the
Circuit Breaker will trip. If the Breaker does trip, unplug the units
and press the Reset button. Then Plug the units back into the
power souce and turn on the switch.
MODEL NO. X-2380 X-2580 X-2480A
VOLTAGE / FREQUENCY
POWER
AMPERAGE
RATED AIRFLOW
SPEEDS
UNIT WEIGHT 23 lbs 23.6 lbs 23.6 lbs
UNIT DIMENSIONS (L x W x H)
CORD LENGTH
HOUSING
DUCT (AIR OUTLET) SIZES
FILTRATION SYSTEM
3-STAGE 4-STAGE 3-STAGE
NFS13 - 13” x 13”
Washable Nylon Mesh Filter
PF13 - 13" x 13"
Pleated Media Filter
WF50 - 13" x 13" x 2" CF15 - 13” x 13” x 0.6” HEPA35-33 - 13” x 13” x 1.4”
Washable Purifying Filter Activated Carbon Filter HEPA Filter
HEPA35-33 - 13” x 13” x 1.4”
HEPA Filter
DAISY CHAIN Yes
FILTER CLEAN/CHANGE LIGHT
STACKABLE
SAFETY CERTIFICATIONS
ETL/CETL
N/A
115 V / 60 Hz
5-Speed Control
ABS
Indicates when the filters need to be cleaned or changed
1/2 HP
2.8 Amps (On Highest Speed)
550 CFM
16.6" x 10.4" x 18.9"
13 ft. / 18AWG
13 ft. / 14AWG
5” x 10.8”
NFR9 - Ø 9"
Washable Outer Nylon Mesh Filter
NFS13 - 13” x 13”
Washable Nylon Mesh Filter
1
ST
STAGE FILTER
2
nd
STAGE FILTER
3
rd
STAGE FILTER
4
th
STAGE FILTER
Up to 5 units high
Item No.
Parts Name
Item No.
Parts Name
1
Removable Air Inlet Foam Cap
2
Air Inlet
3
Inlet Panel
4
Latch
5
13"x13" Nylon Mesh Filter
6
Pleated Media Filter
7
1.4" Thick HEPA Filter
8
GFCI Receptacle
9
Front Housing
10
Motor
11
Motor Bracket
12
Transformer
13
Capacitor
14
Air Valve Bracket
15
Pressure Switch
16
Air Outlet Grill
17
Rear Housing
18
HEPA Filter Clean/Change Light
19
Speed Control Knob
20
Control Panel
21
Switch