User Manual

ManualsBrandsXtremeAir ManualsAppliances30 Inch Under Cabinet Ducted Hood

www.XtremeAirUsa.com PAGE 7

STEP 7: INSTALLING CHIMNEYS - DO NOT REMOVE INNER CHIMNEY PROTECTIVE FILM UNTIL FINISHED INSTALLATION

OPEN: While holding a baffle

filter, pull baffle filter lock down.

Model

PX04 &

PX06

TO REMOVE: While a baffle filter is

open, use both hand to hold both

end of it, then use your index finger

(either left or right) to push baffle

filter hinge pin toward to middle of

baffle filter to release it.

TO INSTALL: Please reverse the

process.

OIL TUNNEL: Drop oil tunnel into recess

support near rear of hood.

Note: PX04 & PX06- skip this step

STEP 6: SECURE THE HOOD BODY & TEST RUN

A. Use a stud finder to find all studs below the hood body. Put blue tape on every stud

found.

B. Use 1/8” drill bit to drill though the back of hood in line with blue tape.

C. Secure the hood body by using the 2.0 inches wood screws (provided) through the

back of hood to the stud.

D. Refer to page 8, Range Hood Operation. Try a few test runs to ensure machine is

running properly.

STEP 6A: FOR PX01 MODEL ONLY – INSTALL GLASS CANOPY

A. Loosen the four canopy screws and washers from the hood top.

B. Carefully place the canopy glass on the hood top then slightly tighten the four

canopy screws along with washers. DO NOT put excessive pressure against the

glass.

10. BAFFLE FILTERS INSTALL & REMOVAL

IMPORTANT: FOR THOSE MODELS THAT HAVE MORE THAN 2 BAFFLE FILTERS, ALWAYS INSTALL THE MIDDLE FILTER LAST WHEREAS REMOVE IT FIRST IF YOU ARE TRYING

TO REMOVE ALL OTHER FILTERS.

Angle baffle filter

toward back of

hood

2. Lift a baffle filter up above horizontal level

then slide forward into slot behind the front of

hood. To remove, please reverse the process

Install & Remove Baffle Filters

A. Remove outter chimney

protective film (not the

inner chimney).

B. Place both chimneys on

top of range hood base.

C. Secure outside chimney

to the base of the hood

(PX02 & DL08 ONLY).

A. Lift up and attach the

innner chimney to the

ceiling mounting

bracket.

B. Screw the chimney into

place on both sides.

C. Remove inner chimney

protective film.