Use and Care Manual

OPERATION

TRANSPORTATION

1. As the engine warms up,gradually move the

choke lever to the OPEN position.

2. Move the speed control lever from the LOW to

the HIGH position. When the engine speed reaches

approximately 2,300-2,600 RPM,the centrifugal

clutch engages. If the engine speed increased very

slowly,it is possible that the clutch can slip. Do not

operate the speed control lever slowly.

OIL ALERT SYSTEM: The Oil Alert System is designed to prevent engine damage caused by an insufcient

amount of oil in the crankcase. Before the oil level in the crankcase can fall below a safe limit the Oil Alert

System will automatically stop the engine(the engine switch will remain in the ON position).

When compacting asphalt,it is advisable to paint the bottom face Of the vibrating plate with diesel fuel.

This will assist in preventing the plate from sticking to the as halt.

When shutting off the vibrator,turn the speed control lever from the HIGH to LOW position. DO NOT move

the speed control lever slowly.

Be sure to stop the engine while transporting. Screw up the fuel tank cap securely and close the fuel valve

to avoid fuel leaking.

If transporting by car, x machine securely not to move nor to fall down. In case of driving for long distance

or at off-road, tank out fuel from tank.

SHUTDOWN

Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3

minutes before stopping.

Tum the stop switch to the OFF position. Close the fuel cock.