Use and Care Manual
OPERATION
FEATURES AND SPECIFICATIONS
Heavy Duty Case With 2 Wheels & Handle
4
COMMON APPLICATIONS:
Piping & wiring installation
Sanitary facility installation
Machinery installation
Water supply & drainage work
Interior work
Civil engineering work
PRIOR TO OPERATION:
1. POWER SOURCE: Ensure that the power source to be utilized conforms to the power specications
on the nameplate.
2. GROUNDING: This tool should be grounded while in use to protect the operator from electric shock.
This tool is equipped with a three conductor cord and grounding type plug to t the proper grounding
receptacle. The green (or green and yellow) conductor in the cord is the grounding wire. Never connect
the green (or green and yellow) wire to a live terminal.
3. POWER SWITCH: Make sure the power switch is in the OFF position. If the plug is connected to a
power receptacle while the power switch is in the ON position. Make sure you are ready to start work
before starting the tool. Failure to do so may cause serious injury.
4. EXTENSION CORD: ALWAYS use an extension cord of sufcient thickness and rated capacity. The
extension cord should be kept as short as is practical.
5. FEEDING OIL: Prior to using the power tool. Remove the oil gauge and ll the oil tank with the provided
oil. Although the oil tank is built in, it contains only a small amount of oil when shipped from the factory.
MOUNTING A TOOL:
(A) Rotate the Stop Lever 180-degrees in a clockwise
direction while pulling it towards you. Next, insert the
tool shank into the hexagonal hole on the front cover.
(B) Clamp the tool by turning the stop lever half a turn in the
opposite direction. NOTE: When removing the tool, follow the
above procedure in reverse order.
COMMON APPLICATIONS:
USING THE HAMMER: After placing the tip of the tool in the
base, hold the switch ON. By utilizing the weight of the machine
and rmly holding the hammer with both hands, one can
effectively control the recoil motion. Proceed at a moderate work
rate. The use off too much force will impair efciency.
CAUTION: Sometimes the tool will not begin the striking stroke even when the motor rotates because the
oil has become too thick. If the tool is used at low temperatures, or if it is used after an extended idle time,
the tool should be used after running it for ve minutes to warm it up.